Is there a specific order in which non-standard flanges should be installed in order to achieve the best results

commentaires · 4 Vues

Flanges are installed in an unconventional mannerThe following is the procedure to be followed when installing flanges that are not in the standard configuration:3

Flanges are installed in an unconventional manner

The following is the procedure to be followed when installing flanges that are not in the standard configuration:


3. For the pipe's port to be functional, it must be flanged at a 90-degree angle to the pipe's wall. The port surface of the pipe must be polished after treatment in order to ensure that there are no burrs, unevenness, or deformation on the port surface of the pipe following the treatment.

 



Install the O-shaped rubber sealing ring with a stainless steel sealing ring installed on both sides into the flange plate with the groove ring and tighten the ring. 6. Remove the O-shaped rubber sealing ring and discard it. Because the non-ASME Flange is drilled, the bolts that connect the two flanges are strong and secure. The non-standard flange is drilled. Gaskets, flange screw joints, welding flanges, and clamp flanges are used to seal the flanges, and low pressure pipes can be used in conjunction with steel wire flanges that have a pressure greater than 4 kilograms. When used in conjunction with welding flanges, the gasket is sandwiched between the two flanges and fastened with bolts on either side of the flange joint.

 


It is possible for all of us to install non-standard flanges by following the installation sequence outlined above to ensure that they are properly installed. When nonstandard flanges are installed correctly, they provide a foundation for efficient operation while also providing a level of assurance for safety during operation.

 

commentaires